Fitting procedure – ARB WINCH BULL BAR User Manual
Page 12
Last Rev Date: 11/05/2009
Page 12 of 13
Fitting instructions# 3786410
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
41. Take cut out trim from OE bumper (Step 4)
and tuck leading edge of plastic trim under
back edge of bumper and use OE retaining
clips in the OE holes to hold bumper piece
into place
42. Snap lower grille trim into place onto bumper
piece.
FITTING PROCEDURE
43. Finished install of trim piece.
When finished make sure all bolts are tightened and that all wiring is clear of hot, sharp and
moving parts.
Also supplied in the kit are two 3/8” rubber grommets and two 16mm plugs. The rubber grommets
are for the two holes in the top pan if lights are being fitted. The two plastic plugs are for the holes
in the top surface of the wings if no CB aerials are going to be connected.