ARB WINCH BULL BAR - Manual (Page 4)

Last Rev Date: 11/05/2009 Page 4 of 13 Fitting instructions# 3786410
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1. Undo bumper light electrical connections and
then remove front bumper cover from vehicle
NOTE: For 03-05 Models only, follow steps 2 to
4 and 44 to 46 regarding plastic trim support.
2. Remove plastic support from inside OE
bumper cover.
3. With trim piece fitted to OE bumper cover as
shown, mark out and draw a line 25mm (1”)
from the leading edge of the lower grille trim
approx. 864mm (34”) long
4. Remove trim and then cut out plastic panel
along marked line from OE bumper facia, set
this piece aside for fitting later.
5. Remove trim piece and support bracket
6. With trim piece removed, mask the area
around the headlight and the front guard and
paint the lower section under the front guard
black.
Paint this
area black
with trim
removed.