ARB 3432160 - Manual (Page 3)

2/02/06 Page 3 of 3 3782640 rev 2
4. Lift bull bar onto chassis rails and refit original bumper bolts through bull bar chassis brackets and chassis
rails. Tread bolts into bumper captive nut plates. Make bolts finger tight.
5. Make sure the bull bar is in correct alignment with vehicle and tighten all nuts and bolts.
6. Drill one 1/2" hole through each chassis rail using the bull bar as a template. Bolt bar into position using
the bolts supplied.
7. Refit registration plate to two outer holes (refer to diagram) using 6mm hardware.
8. For vehicle fitted with forward protruding grille, refit the grille and panel removed during step 2.
9. Wire up winch as per winch manual instructions.
10.
Check operation of winch as per winch manual.
UNDER NO CIRCUMSTANCES IS THE WINCH TO BE USED BEFORE THE OWNER'S MANUAL HAS
BEEN READ & UNDERSTOOD. FAILURE TO COMPREHEND THE MANUAL CONTENTS COULD
RESULT IN OPERATOR DANGER & WINCH FAILURE.
L/ROVER DEFENDER
PLACEMENT FOR 8000LB + 9000LB CONTROL BOX BRKT
PLACEMENT FOR NUMBER PLATE BRKT