ARB 3452020 - Manual (Page 7)

Last Rev Date: 11-Sep-2006 Page 7 of 16 Fitting instructions# 3783239
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE GENERAL
7. Create a starter point with Dia 10.0mm drill
using pilot hole in mount bracket for
alignment. This will be a guide for Dia 7.0
through hole, which will in turn be used to
create a guide hole for Dia 19.0mm hole saw
Step 9.
8. Using the 7.0mm drill, drill right through both
sides of the chassis.
9. Use the Dia 19.0 hole saw, as shown, with
7.0mm hole as a guide to drill a hole through
outer wall of chassis.
10. Then, as shown, using a Dia 10.0 drill, drill
hole through inner wall of chassis.
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.
Warning: Drilling operations can result in flying
metal debris, safety glasses should be worn.
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
worn.