ARB 3452020 - Manual (Page 9)

Last Rev Date: 11-Sep-2006 Page 9 of 16 Fitting instructions# 3783239
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE GENERAL
19. Remove lights from cartons and then
remove screws and speed nuts from each
light. These fasteners are not to be reused –
new screws are supplied in the fitting kit
20. Insert nylon nuts into square holes in light
brackets inside wing area
21. Fit lights using screws supplied in fitting
kit, taking note of RH and LH light bodies,
they are different and must be placed on
the correct side of bull bar.
22. Fit large eyebolt nut into the plate on the
inside of the bar.