ARB 3462010 User Manual
Page 5
27/9/05
Page 5 of 14
3783168
1.4 Remove the bumper by undoing 2 bolts on
the outer rear stabilizer arms, unclip any
lights, then undo the 4 bolts from top.
Remove tow hooks and stabilizer arms
1.5 Position the mount brackets as shown on
the end of the chassis rails. Fit an M12
bolt and washer set as shown finger tight
only.
1.6 Fit M12 x 150 bolt through outer hole in
bracket and through existing horizontal
tow hook holes in the chassis. Do not
tighten.
1.7 Make sure that the bracket is square to
the chassis and back hard against the
chassis mount face.
Using a 12mm drill bit, drill vertically down
through both the top chassis plate and top
of the chassis. Use the hole in the chassis
bracket as a pilot hole
M12 x 150
bolt and
nut set