ARB 3462010 - Manual (Page 6)

27/9/05 Page 6 of 14 3783168
1.8 Remove bracket and fit spacer under
flange next to M12 weld nut lining up with
drilled hole as shown with M12 bolt and
washer set.
1.9 Fit M12 cage nut to small access bracket
and put into place up inside chassis end
for holding spacer bracket in position,
screw M12 bolt in finger tight.
1.10 Fit M12 cage nut to large mount bracket
as shown and fit back into position. Make
sure the LH and RH brackets are parallel
to each other
1.11 When fitting M12x150 bolt set, slide
sleeve over bolt inside chassis to stop
crush of chassis. Fit nut and washer and
nip up (not tight). Fit M12 bolt and washer
set from bottom of chassis into M12 cage
nut.
Sleeve