ARB 5611210 - Manual (Page 4)

08-10-09 Page 4 of 19 3783146
FITTING TAIL LIGHTS TO BAR
1. Compile components as shown.
- Light assembly (LHS shown)
- Light cover
- 6 x M6 x 16mm bolts
- 6 x M6 flange nuts
- 2x M6 cage nuts
- 6 washers to suit M6
2. Fit cage nuts to light cover as shown.
3. Feed looms through large hole in bar.
4. Fit light assemblies using M6 hardware.
Finger tighten only.
5. Repeat steps 1 to 3 for RHS assembly.
Outside of car
When fitting light assemblies to bar,
orange (indicator) lights must be to
the outside as shown. The flange on
the bracket should also be at the top.
Orange light