ARB 4450010 - Manual (Page 3)

06-05-09 Page 3 of 9
3783182
1. Begin by removing the small flare extension or body side moulding & mounting strip
(Sahara & Renegade models only). Also, remove the factory sidesteps or any aftermarket
accessories that may interfere with the installation of the ARB Rocker Guards.
2. Remove the first two rear fender flare bolts (Closest to the door opening).
3. Clean the body side of all dirt and debris. Use a glass cleaner and a clean paper towel or
rag.
4. Position the guard in place along the body side. From below, begin by positioning the
front of the guard, pull away the rear flare from the body side when raising the rear into
place. Using a floor jack, press the guard up until the surfaces of the guard touch the
bottom of the floor pan as shown in Fig. 2. Centre the guard front to rear.
Note: Take caution around the fender flares, they scratch easily.
5. Once the guard is in position (centred front to rear – guard stand-off touching Jeep floor –
tight along the body side), use the ¼” transfer punch to locate the centre of the six 9/32”
holes you’ll drill through the body side. A normal centre punch can be used, but be careful
to locate the exact centres, otherwise assembly will be difficult.