ARB 4450010 - Manual (Page 5)

06-05-09 Page 5 of 9
3783182
8. Position one M6x25 stainless button head screw and neoprene washer through hole #1.
Place a fender washer and M6 Nyloc nut on the inside by reaching up under the fender, in
front of the firewall. Tighten until the neoprene is compressed and the bolt is tight.
9. Assemble the cage nut brackets exactly as shown in Fig. 5. Be sure the cage nuts are
fully clipped into the cage brackets.
10. Pull the rear fender away slightly and position the assembled cage nut and bracket into the
oval hole in the body side; Remove clear tape if present. Using one M6x25 stainless steel
button head screw and neoprene washer – insert through hole #6 (Fig. 6) and carefully
thread into the cage nut. Tighten until the neoprene is compressed and the bolt is tight.
11. Gently push in the part of the cage nut bracket sticking out and fasten rear fender flare
down using stock hardware.