Fitting procedure – ARB 4450220 User Manual
Page 4
Advertising
Last Rev Date: 17/05/2007
Page 4 of 10
Fitting instructions# 3783284
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
FITTING PROCEDURE
1. Remove the original side steps from the
vehicle by removing existing four nuts (A) from
side step studs along sill.
2. Remove two existing bolts (B) and carefully
remove side rail with help of another person.
WARNING – Only remove one side at a
time.
3. Place rubber plugs supplied into the end of the
side rails.
4.
Remove all the bolts which go through to
the sill of the vehicle. Like the one shown in
the photograph on the left.
A
B
A
B
A
Advertising