ARB 4450220 - Manual (Page 7)

Last Rev Date: 17/05/2007 Page 7 of 10 Fitting instructions# 3783284
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
18. Use a centre punch to mark the centre of
the marked hole for the front bracket. Then
using an 11mm drill bit, drill the hole. Be
carefull, as depending on the size of your
drill, the bit will tend to wonder upwards
from the market position.
Remove any sharp burs, and touch up the
bare metal with black paint to prevent
corrosion.
19. Use a centre punch to mark the centre of
the marked hole for the centre bracket.
Then using an 11mm drill bit, drill the hole.
Be carefull, as depending on the size of
your drill, the bit will tend to wonder
upwards from the market position.
Remove any sharp burs, and touch up the
bare metal with black paint to prevent
corrosion.
Refit the side rail as follows.
20. Fit the M12 bolt through the hole into the
bottom of the chassis rail.
21. Fit an M10 cage nut into M10 cage nut
plate and make appropriate bends in cage
nut plate to reach the hole in the top of the
front bracket.
22. Insert cage nut plate through chassis hole
as shown and line up cage nut with hole
and bracket.
23. Using an M10 x 35 bolt, M10 spring washer
and M10 x 25 flat steel washer loosely
fasten into place.
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
worn.
Warning: Drilling operations can result in
flying metal debris, safety glasses should be
worn.