Owner s manual, Inspection, cleaning, and maintenance – Steele Products SP-GG200D User Manual
Page 21
21
Owner s Manual
Inspection, Cleaning, and
Maintenance
WARNING! ALWAYS MAKE SURE THE ENGINE POWER SWITCH IS IN ITS
“OFF” POSITION. DISCONNECT THE SPARK PLUG WIRE FROM THE ENGINE.
AND ALLOW SUFFICIENT TIME FOR THE ENGINE AND GENERATOR TO
COMPLETELY COOL BEFORE PERFORMING ANY INSPECTIONS,
MAINTENANCE, OR CLEANING.
• Before each use, inspect the generator. Check for:
-
Loose screws
-
Misaligned or binding moving parts
-
Cracked or broken parts
-
Damaged electrical wiring
-
Any other condition that may affect safe operation.
• If an engine problem occurs, have it checked by a qualified service technical before further use.
Do not use damaged equipment.
• Before each use, make sure the engine’s oil and gas levels are adequate. If necessary, fill the
crankcase until the oil level is even with the oil hill hole and/or fill the fuel tank.
• Before each use, remove all debris with a soft brush, rag, or vacuum.
• Lubricate all moving parts using a premium
quality, lightweight machine oil.
• First 20 hours of use, drain the old engine oil and
replace with high quality SAE 10W-30 grade engine oil.
This is only required for the break-in period.
• Every 100 hours of use, change oil.
• For long term storage, either drain fuel into
suitable container or add a fuel preservative/
stabilizer (not included) to prevent fuel
breakdown.