L.B. White 170 Dual Fuel - Manual (Page 11)

POWER CORD
HEAVY DUTY
EXTENSION CORD
WITH GROUND
SERIES TAP PLUG
THERMOSTAT
11
1. Connect male plug on heater into female side of
series tap plug on thermostat. See Fig. 7
2. Plug male side of series tap plug into grounded,
heavy-duty, electrical extension cord. Plug extension
cord into approved electrical outlet.
FIG. 7
THERMOSTAT ASSEMBLY
SIDE W
ALL
10 FT
CLEARANCE
EARLIER STYLE DUCTING
DUCT KIT ASSEMBLY
Accessory 26346
FASTEN WING SCREWS
INTO CAGE NUTS AT
BLOWER OUTLET AND
TIGHTEN
INSTALL TAB AT BOTTOM OF COLLAR
INTO SLOT AT BOTTOM OF OUTLET
BEFORE FASTENING WING SCREWS
SLOTS FOR INSTALLING
EARLIER STYLE DUCTING
SIDE W
ALL
1. Extend duct kit to 3.65 m. length.
2. See Fig. 8 for installation of duct. Hand tighten the
screws snugly. (Note: Slots are also provided at the
sides of heater’s air discharge to accomodate earlier
style duct adapters with tab mounting configuration.)
3. Position duct as shown. Eliminate any kinks in duct.
FIG. 8
3.04 m.
CLEARANCE