L.B. White 170 Dual Fuel - Manual (Page 9)

9
HANDLE BRACKET
EXTEND HANDLE
UNTIL IT SNAPS INTO
RETAINING HOLE
RETAINING HOLE
AT UNDERSIDE
SNAP BUTTON
AT UNDERSIDE
The Premier 170 is equipped with sliding handles for
convenient “wheel-barrow” style mobility.
-- Depress the snap-button on the underside of the
sliding handle storage bracket.
-- Fully extend both handles until the snap button locks
into place.
-- For storage, depress the snap button and push the
handles to fully retracted position.
FIG. 1
SLIDING HANDLE
1. Hose Hanger Assembly
a. Align wire hose hanger to cage nuts on back of
heater.
b. Mount the hanger using the 1/4-20 x 3/4 in. bolts
and 1/4 in. flat washers. Tighten securely. See
Fig. 2.
2. Thermostat Storage Bracket Assembly
a. Align regulator storage bracket to the four 1/8 in.
diameter holes on heater case back.
b. Mount the storage bracket to the case using the
four 3/8 in. hex head screws. Tighten securely.
See Fig. 2. Store the thermostat as shown in Fig.
3 when not in use.
3. Regulator Storage Bracket Assembly
a. Align regulator storage bracket to the two 1/8 in.
diameter holes on heater case back.
b. Mount the storage bracket to the case using the
two 3/8 in. hex head screws at this point. Tighten
securely. See Fig. 2.
FIG. 2
FIG. 3
Thermostat Storage
HOSE HANGER, REGULATOR STORAGE BRACKET
& THERMOSTAT STORAGE BRACKET ASSEMBLY
TS170DF-03
REGULATOR STORAGE
BRACKET
CAGE NUTS
HOSE HANGER
FLAT WASHER
BOLT
THERMOSTAT STORAGE
BRACKET
(INSTALLED WITH INTERNAL
SUPPORT TO THE LEFT)
SCREWS
HEATER CASE SIDE
THERMOSTAT CASE
RESTS ON SUPPORT
BRACKET
INTERNAL VIEW