Fast & Fluid SK350 - Manual (Page 6)

Fast & Fluid Management – SK350
V 2.0 page 6
Installation
Step 1 - Unpack the machine and unlock the frame lock
> >
Remove box and plastic
foil. Note the frame lock
bolts on either side of the
machine.
Remove both bolts with a size
17 fork wrench.
By removing the bolts, the
frame lock’s wooden block is
released.
Be careful not to damage the body and surfaces of your SK350 with
any tools while unpacking it. Take care not to accidentally close the
door before finishing installation, as it can then only be unlocked
power on the machine.
Step 2 - Remove the frame lock
> >
Pull out cord to
remove frame lock’s
loose parts.
Ensure all loose parts
have been removed – two
bolts and two wooden
blocks.
Connect the SK350 to the
power mains before
closing the door.
Attention! Failure to remove the frame lock correctly can result in
severe damage to your SK350 when in operation. Please take care!
Please take care to store the frame lock for later use, it is essential for
correct transportation.