Poison Spyder LJ FULL CAGE KIT - Manual (Page 5)

INSTALLATION INSTRUC
TIO
NS
Poison Spyder Customs • LJ FULL CAGE KIT INSTALL Page 5
©2013 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
in place. Start by holding the A-Crossbar
in place between the two Main Side Hoops,
toward the front of the Jeep. Next, hold the
two Forward Stringers in place between the
A-Crossbar and the B-Crossbar. Use the
laser-etched marks on each of the tubes to
properly locate the tube junctions. Use the
Forward Stringers to locate the A-Crossbar
the proper distance forward from the
B-Crossbar. While holding them in place
correctly located, tack the A-Crossbar and
Forward Stringers into place. Ratchet straps
may be useful in holding everything together
while aligning and tacking.
FIGURE 10
11. Install the C-Hoop 14 and the C-Pillars L&R
15 at the same time. Have a friend help
with holding the three pieces in place. Start
by holding the C-Hoop in place, extended
rearward from the downward bend on each
Main Side Hoop. Next, hold the two C-Pillars
in place vertically between the C-Hoop and
the lower ends of the Main Side Hoop. While
holding them in place correctly located, tack
the C-Hoop and C-Pillars into place.
FIGURE 11
12. Install the Rearward Stringers L&R 13
between the B-Crossbar and the inside
bends of the C-Hoop. Use the laser-etched
assembly marks to properly locate and align
the tube junctions. While holding these in
place, also insert the Rear Stringer Spreader
Bar between them. Tack weld all of these
pieces once they are properly aligned. Note
that the image below depicts a TJ, which
differs slightly from the LJ in terms of the
shape of the Rearward Stringers, and it also
does not show the Rear Stringer Spread Bar.
FIGURE 12
13. Install the Upper A-Pillar Tubes L&R 7
and the Dash Bar 9 at the same time. Have
a friend help with holding the three pieces in
place. Start by holding the Upper A-Pillar
Tubes in place between the Lower A-Pillar
and the Main Side Hoop. Next, hold the two
Dash Bar in place horizontally between the
C-Hoop and the lower ends of the Main Side
Upper A-Pillar Tubes. Use the laser-etched
assembly marks as guides to properly locate
the tube junctions. While holding them
in place correctly located, tack the Upper
a-Pillar Tubes and Dash Bar into place.
FIGURE 13
14. Install the Seatbelt Bar 16 to the rearward
side of the B-Pillars. Use the laser-etched
assembly marks as guides to properly locate