SkyTrak 6042 Service Manual - Manual (Page 423)

9.53 Model 6042 Legacy Origin 7/02
Electrical System
Not
OK
Replace roadlight
harness.
Replace lighting
control.
Not OK If OK
Disconnect three position
plug at lighting control and
check for voltage at roadlight
harness pin C, wire 1C
(RED).
Replace bulb.
If OK
Not
OK
Replace roadlight
harness.
Replace lighting
control.
Not OK If OK
Disconnect three position
plug at lighting control and
check for voltage at roadlight
harness pin C, wire 1C
(RED).
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.
3. Before troubleshooting
either the position lights
circuit or the low beam
lights circuit, verify that
the worklight circuit is
operating. If not, follow
the steps listed at,
Section 9.7.27,
“Roadlights Worklights
Circuit and
Troubleshooting
(Option),” before
troubleshooting either
the position lights circuit
or the low beam lights
circuit. If one position light is not
ON, verify voltage at that
position light, pins
2J & 20A (Left Front),
2H & 20B (Right Front),
2F & 20D (Right Rear) or
2E & 20C (Left Rear).
Replace bulb.
If OK
With the ignition ON and
the lighting control rotated
to 1st position (Position
Parking Lights Only),
position lights remain OFF.
If one low beam light is not
ON, verify voltage at that low
beam light, pins
2J & 21A (Left Front),
2H & 21B (Right Front).
With the ignition ON and
the lighting control rotated
to 2nd position (Position
Parking Lights &
Headlights) and pulled
back for low beam lights
ON, low beam lights
remain OFF.