PureFlow AirDog RP-150 - Dodge Cummins 2005-2013 - Manual (Page 10)

10
Raptor™ 100 & 150
2005 – Present Dodge Cummins
Section 5 Fuel Lines
Section 5A: Connecting the Raptor™ to the Filter Canister.
5A-1. Remove the original Banjo Bolt and fuel supply line from the factory fuel filter canister.
Figure 7 Figure 8
5A-2. Install the 12mm X ½” Male SAE J2044 Quick Connect Fitting with seal washer
supplied into the inlet port on the fuel filter canister. Properly torque the fitting. Do not
over tighten. The fitting could crack or break!
5A-3. Insert the female quick connect end (see figure 9) of the
“Pressure Hose Assembly” into the male quick connect fitting
previously installed in the port marked “OUT”. You will hear a
“click” when it connects.
Figure 9
5A-4. Connect the other end of the “Pressure Hose Assembly” (Figure 10) to
the inlet fitting installed in step 5A-2. It will “click” when properly connected.
Figure 10
5A-5 Any excess fuel hose can be addressed by routing the hose in a fashion to take up the
extra length, or a section of the hose can be removed. Push lock splices have been
included if you choose to remove the excess hose.