Installing the raptor™ fuel pump wiring harness – PureFlow AirDog RP-150 - Dodge Cummins 2005-2013 User Manual
Page 12
12
Raptor™ 100 & 150
2005
– Present Dodge Cummins
Section 6 Electrical Harness
WIRING DIAGRAM
Figure 13
Installing the Raptor™ Fuel Pump wiring harness.
6-1.
Connect the Power Supply Lead to the Raptor™, by inserting the 2 pin Deutsch
connector on the end of the wiring harness into the corresponding connector on the
Raptor™.
Figure 14
6-2.
Crimp the male spade connector on the end of the Red (+) wire.
Ground Wire
Hot Lead
Water Proof Fuse
Raptor Pump Lead
Figure 15
Figure 16
6-3.
To connect to the power lead to the fuse panel, route the Red (+) wire to the fuse panel
located under the hood on the driver’s side wheel house and insert the male spade
connector into a spare fuse holder on the panel that is “hot” when the starter key is turned
to the on position.
6-4.
Connect the Green (-) wire to an adequate ground.
BE SURE TO PROPERLY ROUTE AND SECURE THE WIRING HARNESS TO THE
VEHICLE.