Hyline Offroad TJ LOUVERED HOOD PANEL FOR 03-06 WRANGLER - Manual (Page 2)

PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
*** BEFORE INSTALLING ***
If you ordered the Hood Louver Panel raw you should paint, anodize, powder coat, etc. now before
installation onto vehicle. PEEL OFF THE VINYL PROTECTANT COVERING BEFORE PAINTING OR
FINISHING. If Hood Louver Panel was was ordered black powder coated your now ready to continue
to step 1.
Hood Louver Panel Installation
Step 1 – As a safety precaution - Remove the hood from your vehicle before drilling or cutting. First, remove the
engine grounding strap, hood light, and/or windshield washer hose from hood. Then unbolt the 6 Torx
bolts from the hood hinges. Hood should now be free to remove from vehicle.
Step 2 – Once the hood is removed, place the hood on a flat, solid work area. Then remove the two rubber
windshield bumpers and the u-shape tie down bracket. The rubber bumpers are easily removed by
pulling up and away from hood. Tie down bracket unbolts from under the hood.
Step 3 – Place steel template in the center of hood as seen
in (Figure 1).
Visually make sure the holes in the template are centered
with the holes for the rubber windshield bumper, tie
down bracket holes and windshield washer squirter.
Step 4 – Re-install the U-Shape tie down bracket and tighten nuts
securely, as these will hold the template in place while drilling
Figure 1
in Step 6.
T:\Hyline Offroad, LLC\Installation Instructions\TJ-50HLP(D)\TJ-50HLP(D) Installation Instructions.doc
Page 2 of 2
REV 0 12/2/08