Important** do not move template until step #9 – Hyline Offroad TJ LOUVERED HOOD PANEL FOR 03-06 WRANGLER User Manual
Page 3
Step 5 – Place masking tape on the hood around perimeter of template, if desired, to prevent excessive
scratching.
NOTE: USE 1/16” BIT AS PILOT HOLE FOR 1/4” BIT TO BETTER ENSURE ACCURACY!
Step 6 – Using 1/4” Bit, drill one hole through the template
and hood at either corner, as shown in (Figure 2).
Install and tighten the supplied 10-32 screw and nut.
Then drill a second hole in the opposite corner of
Template and install and tighten supplied 10-32 screw
And nut. This will ensure template stays in place
while drilling and cutting.
**Important** DO NOT MOVE TEMPLATE UNTIL STEP #9
Figure 2
Drill & Install second 10-32 screw
here.
Drill & Install first 10-32 screw here.
Step 7 – Continue to drill the rest of the holes with the 1/4” Bit, 32 Holes Total.
**NOTE** You will need to use the 1” hole saw to expand
the center bottom hole under the hood in the support
section in order to attach the nut to stud. See (Figure 3)
Figure 3
T:\Hyline Offroad, LLC\Installation Instructions\TJ-50HLP(D)\TJ-50HLP(D) Installation Instructions.doc
Page
3
of
3
REV 0 12/2/08