Hyline Offroad TJ LOUVERED HOOD PANEL FOR 03-06 WRANGLER - Manual (Page 4)

T:\Hyline Offroad, LLC\Installation Instructions\TJ-50HLP(D)\TJ-50HLP(D) Installation Instructions.doc
Page 4 of 4
REV 0 12/2/08
just enough until they touch the hood steel.
DO NOT OVERTIGHTEN NUTS. Overtightening
Step 10 – Install the Hood Louver Panel onto hood and assemble nylon locknuts to threaded studs. Tighten nuts
Step 8 – Once drilling is completed, Use 1” Hole saw and drill each corner of the 6 panels (24 times total). With
template still in place, use jigsaw/cutoff wheel to cut out all 6 panels.
Step 9 – Remove template and use a file or sandpaper to deburr any sharp edges from panel cutouts and/or
drilled holes. Remove masking tape also if necessary.
will cause distortion on Hood Louver.
Step 11 - Re-install hood onto vehicle and re-mount the two
rubber windshield bumpers and u-shape tie down
bracket. That’s it, you’re done.
Send your OFFROAD pictures to [email protected] . If we choose any one of your pictures to be used on
our website, We send you a FREE Hyline Offroad T-Shirt.
Installation instructions provided must be read and followed exactly when installing
product. Failure to do so could potentially result in injury or death of any occupants
in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!
Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications
Attention