AEM 25-111BK High Volume Fuel Rail User Manual
Page 6
5) Finishing Touches
a) Connect the negative battery terminal.
b) Turn the ignition switch to the on position for approximately two seconds. Do not operate the starter.
Then turn the ignition switch to the off position.
c) Repeat this procedure three times, and then check all components that were removed during installation
for any signs of fuel leakage.
i)
Be sure to check the area around the fuel inlet fitting, the –6 plug and the 1/8” NPT plug. If
these three items were not installed correctly then they may be prone to leak.
d) If there are signs of leakage you MUST correct the leak before proceeding.
e) If there are no signs of leakage, then start engine and again check for leaks. If there is any sign of
leaking you MUST repair the leak before driving the vehicle.
Bill of Materials for: 25-111
1
2-5010
Fuel Rail Body
1 2-5011
Fuel
Rail
Cover
2
1-121
1/8" Pipe Plug
3 1-3007
Crush
Washer
4 1-3030
O-Ring
2 2-604
Fuel
Plug
2
10-922S
AEM Silver Decal
1 10-327
Instructions
1 2-602
Fuel
Fitting
1 1-3017
Crush
Washer
2
1-2050
8-32 X 3/8" SS Flat Head Cap
1
2-350
Banjo Fuel Line
For Technical Inquiries
Please E-Mail us at