AEM 30-3432 Series 2 AEMnet Adapter - Manual (Page 4)

Page 4
2. Next remove the pin from the plastic connector by lightly prying on the plastic tabs that
secure the pin in the plastic connector while gently pulling on the wire at the same time as
shown in figures 4 and 5.
Figure 4: Pry this tab up with the screwdriver or paper clip to release pin
Figure 5: While prying tab, gently pull wire back
3. If the screwdriver does not fit in the area of the plug, a ground paper clip can be used to
release the tabs of the plug as shown in figure 6.
Figure 6: Grind a paper clip like this