AEM 30-3501 Infinity Plug & Play Harnesses - Honda/Acura OBD1 - Manual (Page 5)

1992–1995 Honda B-H-D Series OBD1 5
© 2014 AEM Performance Electronics
The gray Deutsch 12P DTM “AUX” connector is used
to adapt many common ancillary inputs and outputs
easily. Included in the kit are a DTM 12P mating
connector, 12 DTM terminals, and a DTM 12P
wedgelock. If used, these components will need to be
terminated by the installer or end user with 16
– 22awg
wire (not included). Note: The pin numbering is
molded into the connector, as shown.
30-2860 HONDA B-SERIES COIL-ON-PLUG CONVERSION KIT
The 30-3501 AEM Infinity Adapter Kit is ideal for use with AEM’s Honda B-Series Coil-on-Plug
conversion kit. Refer to the table below for pin locations to cross reference with the 30-2860 COP
Conversion Kit instruction manual.
Once the appropriate wiring connections have been made, use the Infinity Tuner Setup Wizard to
configure the ECU to run with the AEM EPM and for sequential COP coil triggers. There are no jumper
changes required as with AEM Series1 and Series 2 ECUs.
Setup Wizard
Engine
Ignition Type = Sequential (Coil on Plug)
Firing Order = 1-3-4-2
Cam/Crank
AEM EPM (Engine Position Module)
Ignition Sync: Follow instructions in AEM Infinity Quick Start Guide for proper ignition sync
procedure.
PIN 30-7106 Infinity-6 30-7108 Infinity-8h
30-3501 Adapter
Harness EPM Harness
COP
Harness
Coil 1 C1-14 C1-14 Coil Connector - 1 NA Orange
Coil 2 C1-13 C1-13 Coil Connector - 2 NA Blue
Coil 3 C1-12 C1-12 Coil Connector - 3 NA Pink
Coil 4 C1-11 C1-11 Coil Connector - 4 NA Gray
Cam C1-26 C1-26 C1-26 White NA
Crank C1-25 C1-25 C1-25 Green NA
Pwr
Gnd
C1-33, C1-43, C1-
46, C1-67
C1-33, C1-43, C1-46,
C1-67 C1-46, C1-68 Drain NA
Sw +12 C1-63, C1-68 C1-63, C1-68 Aux Connector - 8 Red NA
Sensor
Gnd C1-23, C1-24 C1-23, C1-24 Aux Connector - 3 Black NA