AEM 30-4900 Wideband Failsafe Gauge - Manual (Page 19)

Page 20
4. Insert the AEMnet+ terminal (white wire) into the available Pin 13 on the Wideband Failsafe
connector. Push the wire in until the locking mechanism on the terminal and connector lock into
place. Pull lightly on the white wire to confirm the locking mechanism has latched. Figure 4 below
shows the correct placement of the AEMnet+ terminal.
Figure 4
5. Insert the AEMnet- terminal (green wire) into the available Pin 12 on the Wideband Failsafe
connector. Push the wire in until the locking mechanism on the terminal and connector lock into
place. Pull lightly on the green wire to confirm the locking mechanism has latched. Figure 5 below
shows the correct placement of the AEMnet- terminal.
Figure 5
6. Connect the Deutsch connector on the opposite end of the AEMnet harness to a mating Deutsch
connector on a second device with AEMnet capabilities. The AEMnet harness includes a male and
female Deutsch connector, allowing AEMnet devices to be daisy-chained together.