Bissell MAX 21H6 - Manual (Page 7)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
7
O
perations
Getting ready continued
B. Unscrew the cap at the bottom of
the water tank and remove the insert
assembly.
C. Fill the water tank with water. For
best results, water should be at room
temperature.
D. Replace the insert assembly and cap,
tighten until snug.
E. Replace the water tank by lining up
the vertical guides and gently sliding it
back into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely, and plug it into a 120-volt
outlet as described on the Important
Safety Instructions page.
4. The ready light will illuminate when the
Steam Mop Max is ready for use.
Before you clean
Thoroughly sweep or vacuum floor
prior to cleaning with the Steam
Mop Max.
Cleaning hard floors
Your Steam Mop Max is designed to
clean hard flooring such as ceramic
tile, vinyl, marble, stone and sealed
hard wood floors. Use of your Steam
Mop Max on waxed or some unwaxed
floors may result in a diminished glossi-
ness. The Steam Mop Max is not for
best results, test in an inconspicuous
area and check the care instructions
from your flooring manufacturer.
1. When the ready light illuminates, begin
cleaning by slowly passing over the sur-
face while pressing the steam on demand
trigger to emit steam as needed.
2. To sanitize an area of your floor, (attack
invisible germs and bacteria) put the
center of the Steam Mop Max over the
spot for a minimum of 15 seconds using
continuous steam, but no longer than 20
seconds. For larger areas, overlap swivel
head placement.
2E.
2B.
WARNING:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
Tip:
Upon first use of the Steam
Mop Max or first use of a new
filter, the pump may make a
"KNOCKING" sound while filter
fills with water. This is normal and
will last between 30 seconds to a
minute. Continue to depress the
trigger until the "KNOCKING"
subsides and the unit begins
emitting steam.