Bissell MAX 21H6 - Manual (Page 9)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
9
M
aintenance and care
When you’re done
1. Unplug power cord from outlet.
2. Carefully remove mop pad from
swivel head, as mop pad and lower
assembly will be hot.
3. Any water remaining in the water
tank should be emptied prior to
machine storage.
4. Mop pad can be machine washed in
warm water with mild detergant. For
best results, air dry. Do not use
fabric softeners.
5. Wrap power cord around quick
release cord wrap on side of Steam
Mop Max.
6. Wipe all surfaces of Steam Mop Max
with a soft cloth. Store upright in a
protected, dry area.
NOTE: If steam output is reduced,
the nozzle may be blocked. To
remedy, unplug unit, remove
swivel head from lower body
and pour vinegar through cen-
ter tube of swivel head “neck”.
Clear nozzle by inserting a paper
clip into the brass spray tip
located in bottom of lower body.
If you fill your Steam Mop Max
cleaner with normal tap water,
it is essential to check the water
purification system and replace
it when it is no longer effective.
Change the filter when the bright
green grains turn blue. If the
filter is not changed at the appro-
priate time, calcium deposits will
accumulate on the heating element,
causing damage or reduced
performance.
Using distilled or demineralized
water will maximize the perfor-
mance of your filter.
To order a replacement water
purification system refer to the
replacement parts section on
page 11.
CAUTION:
Upright storage of the
Steam Mop Max with a wet
mop pad may result in the
formation of white marks
on your floor. To remove
the white marks, clean area
with vinegar.
Tip:
Using distilled or demineralized
water will maximize the
performance of your filter.
Tip:
Be sure to use only a BISSELL
water filter in your Steam Mop
Max.
Replacing the water purification system
Brass Spray Tip
Swivel Head Neck