Bissell MAX 21H6 - Manual (Page 8)

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
O
perations
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Cleaning hard floors continued
3. When the Steam Mop Max stops
emitting steam, turn the unit off and
unplug it. Simply remove the water
tank, refill, plug back in, and
continue cleaning.
Carpet refresher attachment
This accessory is recommended
for the refreshing of carpets.
Once the steam mop is cradled in
the carpet refresher attachment, it
will easily glide over the carpet.
NOTE: Always be sure a mop
pad is in place before placing
in carpet refresher attachment.
Only white mop pads should
be used with the carpet attach-
ment. Do not use carpet attach-
ment on spots or stains, or
glide it over the same spot for
longer than 20 seconds.
1. Attach the mop pad to the swivel mop
head. As directed in step 1 on page 6.
2. Place the swivel mop head, with
mop pad attached, in the carpet
refresher attachment.
Note: that the Steam Mop rests in
the carpet refresher attachment
and may not stay attached to the
swivel mop head. It is meant to
glide over the carpet.
3. Fill the water tank with water. Begin
refreshing your carpet or rug by
pushing the Steam Mop in a
forward and backward motion,
releasing steam as you go.
4. When you have finished refreshing your
carpet or rug, unplug the steam mop
and remove from the carpet or rug.
NOTE: Move the Steam Mop
and carpet refresher attach-
ment in a continuous motion
until you are finished. This
product is not intended to be
used as a carpet cleaner, only a
carpet refresher or deodorizer.
Never attempt to use the Steam
Mop on carpet without the
carpet refresher attachment in
place. DO NOT leave the mop
in a stationary position.
8
CAUTION:
Never put descaling
aromatic, alcoholic, or
detergent products into
the steam cleaner, as this
may damage it or make it
unsafe for use.
2
3