AEM 30-8761 CAS Trigger Disc - Manual (Page 15)

Page 15 of 25
This step requires a lot of finesse or help from a friend to hold the shaft from falling
off the vise. Mark the star socket relative to the shaft and remove the pin holding the
star socket onto the shaft using a 1/8” pin punch as shown in figure 25.
Figure 25: Removal of pin using 1/8” pin punch
Remove the star socket with a ¼” flat screwdriver as shown in figure 26. Figure 27
shows the star socket removed with the small rubber seal that is inside it.
Figure 26: Removal of star socket using ¼” flat screwdriver