Input function assignment, Pinouts, Infinity pinout – AEM Infinity Supported Applications - Dodge 2008-2010 Viper 4G User Manual

Page 9: Infinity supported application 9

Advertising
background image

Infinity Supported Application

9

© 2014 AEM Performance Electronics

Input Function Assignment

In the Input Function Assignment tab, choose Vehicle Speed Input and confirm the following setting:

Vehicle Speed Calibration = 0.44

PINOUTS

Infinity Pinout

Dedicated

Dedicated and not reconfigurable

Assigned

Assigned but reconfigurable

Available

Available for user setup

Not Applicable

Not used in this configuration

Required

Required for proper function

Infinity

Pin

Hardware Reference

08–10 Dodge

Viper Function

08–10

Dodge

Viper Pin

Destination

Hardware Specification

Notes

External Hbridge

Output of
Generator

Control H-Bridge

C3-5

Pin 1 of TLE 5205-2G Hbridge

External Relay

Ignition Switch

Output (Start)

C3-36

Pin 1 of V23374-A1601-X008 Relay

External Relay

Starter Relay

Control

C4-5

Pin 2 of V23374-A1601-X008 Relay

C1-1

LowsideSwitch_4

A/C Relay

Control

Lowside switch, 4A max,
NO internal f ly back diode.

See "LowSide Assignment Tables" f or
output assignment.

C1-2

LowsideSwitch_5

LS5

C3-12

Lowside switch, 4A max
with internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.

See Setup Wizard Page "LowSide
Assignment Tables" f or output
assignment and 2D table "LS5_Duty
[%]" f or activ ation.

C1-3

LowsideSwitch_6

LS6

Gen Hbridge

control (Pin 5

of TLE 5205-

2G Hbridge)

Lowside switch, 4A max
with internal f ly back diode.
Inductiv e load should NOT
hav e f ull time power.

See Setup Wizard Page "LowSide
Assignment Tables" f or output
assignment and 2D table "LS6_Duty
[%]" f or activ ation.

C1-4

UEGO 1 Heat

UEGO 1 Heat

Bosch UEGO controller

Lowside switch f or UEGO heater
control. Connect to pin 4 of Bosch
UEGO sensor. NOTE that pin 3 of the
Sensor is heater (+) and must be power
by a f used/switched 12V supply .

C1-5

UEGO 1 IA

UEGO 1 IA

Trim Current signal. Connect to pin 2 of
Bosch UEGO sensor.

Advertising