Class1 118711 - TPG+ Governor - 118710 EXTERNAL - Manual (Page 9)

FORM-ENG-0018 REV A 05-27-03
PAGE 8 OF 30
TECHNICAL DATA SHEET
DATE 4/9/2009
PRODUCT GROUP THROTTLE CONTROL P/N 118710 REV 1.00
607 NW 27th Ave
Ocala, FL 34475
Ph: 352-629-5020 or 1-800-533-3569
Fax : 352-629-2902 or 1-800-520-3473 PRODUCT TOTAL PRESSURE GOVERNOR PLUS (TPG+) BY AMS
Manual P/N 118711
3.6. Battery voltage monitor
The battery voltage monitor is comprised of three (3) LEDs (green, yellow, and red). The active LED color indicates
the current system voltage’s range as measured by the power and ground inputs pins. The alarm will activate when
the voltage monitor is in condition RED.
•
GREEN 12.5VDC and higher
•
YELLOW 12.4VDC to 11.9VDC
•
RED 11.8VDC and lower
3.7. Coolant temperature monitor
The coolant temperature monitor is comprised of three (3) LEDs (green, yellow, and red). The active LED color
indicates the status of the coolant temperature as reported by the Diagnostic Message 1 (DM1) SAE J1939 network
data message transmitted by the vehicle ECU. The coolant temperature status can also be set to react to user
desired points (see section 5.2.22). The alarm will activate when the coolant temperature monitor is in condition
RED.
•
GREEN No active error reported by engine for coolant temperature
•
YELLOW Coolant temperature high WARNING – SPN 110, FMI 16
•
RED Coolant temperature high CRITICAL – SPN 110, FMI 0
3.8. Oil pressure monitor
The oil pressure monitor is comprised of three (3) LEDs (green, yellow, and red). The active LED color indicates the
status of the oil pressure as reported by the Diagnostic Message 1 (DM1) SAE J1939 network data message
transmitted by the vehicle ECU. The oil pressure status can also be set to react to user desired points (see section
5.2.22). The alarm will activate when the oil monitor is in condition RED.
•
GREEN No active error reported by engine for oil pressure
•
YELLOW Oil pressure low WARNING – SPN 100, FMI 18
•
RED Oil pressure low CRITICAL – SPN 100, FMI 1
3.9. Pump intake pressure display
The pump intake pressure display shows the pressure as determined by the intake pressure sensor. By default, this
display shows positive pressure in pounds per square inch (PSI) and negative pressure (vacuum) in inches of
mercury (inHg), but it may be set up to display in metric units (see section 6.1).
3.10. Pump discharge pressure display
The pump discharge pressure display shows the pressure as determined by the discharge pressure sensor. By
default, this display only shows positive pressure in pounds per square inch (PSI), but it may be set up to display in
metric units (see section 6.1).
3.11. Stop engine and check engine indicators
The stop engine and check engine indicators are turned ON and OFF as directed by the Diagnostic Message 1 (DM1)
SAE J1939 network data message transmitted by the vehicle ECU.