Apple Xserve RAID: Using RAID 1.2 Admin and Disk Utility - Manual (Page 29)

Chapter 3 Monitoring Status and Changing Settings 29
Removing a System From the Monitoring List
You can take a system off the monitoring list when you’ve finished adjusting or
monitoring it.
Note: If you remove a system, you must supply its IP address and monitoring password
when you add it again.
m To remove a system from the monitoring list, select it in the list and click Remove
System.
Changing RAID Admin Preferences
You can change status buttons to shapes in the main RAID Admin window and change
the time display to a 24-hour clock using the application’s preferences.
To use shapes or buttons to indicate system status:
1 Choose RAID Admin Preferences.
2 Check or uncheck “Use shapes to indicate status” to use shapes in addition to color for
status indicators, then click OK.
Use the “shapes to indicate status” option if you have difficulty distinguishing between
the different colored status indicators. When shapes are turned on, you see a green
circle for OK, a yellow triangle for warning, and a red square for failure status.
To adjust time settings for the event log:
1 Choose RAID Admin Preferences.
2 Click either “12-hour clock” or “24-hour clock” and click OK.
Changing System Settings
You can adjust most settings for the Xserve RAID system while the system is operating.
In a few instances, the Xserve RAID system must restart for a change to take effect,
temporarily disrupting data availability.
Revising Basic Information and Network Settings
See “System Name and Contact Information” on page 11 for instructions on adjusting
basic system settings, including changing passwords for management and monitoring
access.
See “Network Address” on page 12 for instructions on adjusting the network
information.