Apple Xserve Intel (Late 2006) DIY Procedure for Logic Board - Manual (Page 13)

Xserve (Late 2006) Logic Board Replacement Instructions 1
Disconnect the optical drive cable from the logic board.
Release the two locking levers on the front panel board cable connector and disconnect the
cable from the logic board. Move the cable aside so you have access to the logic board.
Loosen the single thumbscrew on the power distribution board and slide the board away
from and out of the connector on the logic board.
Note: Don’t remove the power distribution board but make sure its edge connector is all the
way out of the connector on the logic board.
1.
2.
3.