Apple Shake 4 - Manual (Page 241)

Chapter 7 Using the Node View 241
Loading Node Parameters
In order to modify a node’s parameters, you must first load them into one of the two
Parameters tabs. The Parameters tabs remain empty until you click the right side of a
node (or double-click the node).
To load a node’s parameters into the Parameters1 tab, do one of the following:
m Click the right side of the node.
The parameters indicator appears on the right side of the node.
Note: The node does not have to be selected in order to load its parameters into either
of the Parameters tabs.
m Double-click anywhere on the node to load its parameters into the Parameters1 tab
and its image into the Viewer.
To load a node’s parameters into the Parameters2 tab:
m Shift-click the right side of the node.
Loading a node’s parameters into a tab automatically clears out whatever previous
parameters were loaded. If necessary, you can clear a Parameters tab at any time.