Apple AirPort Time Capsule 802.11n (3rd Generation) - Manual (Page 10)

10 Chapter 1 Getting Started
 Mac OS X v10.5.7 or later
 AirPort Utility v5.5 or later
To set up your Time Capsule using a Windows PC, you need the following:
Â
A Windows PC with 300 MHz or higher processor speed and a compatible 802.11a,
802.11b, or 802.11g wireless card, or a wireless card that complies with an IEEE 802.11n
draft specification, or a Windows computer connected to a Time Capsule with an
Ethernet cable to set it up using Ethernet
 Windows XP Home or Professional (with Service Pack 3 installed) or Windows Vista
(with Service Pack 1 installed)
 AirPort Utility v5.5 or later
Plugging In Your Time Capsule
Before you plug in your Time Capsule, first connect the appropriate cables to the ports
you want to use:
 Connect the Ethernet cable that’s connected to your DSL or cable modem (if you will
connect to the Internet) to the Ethernet WAN (< ) port.
 Connect a USB cable connected from the USB (d ) port on your Time Capsule to
a compatible USB printer (if you will print to a USB printer), a hard disk, or a hub.
 Connect an Ethernet cable from any Ethernet device to the Ethernet LAN (G ) ports.
After you’ve connected the cables for all the devices you plan to use, connect the
power cord to the power port and plug your Time Capsule into a power outlet. There
is no power switch.
Important: Use only the power cord that came with your Time Capsule.