Apple PC Compatibility Card 7-inch card - Manual (Page 159)

Installing Microsoft’s TCP/IP-32 IP protocol stack in Windows for
Workgroups
Follow these steps to set up Microsoft’s TCP/IP-32 IP protocol stack for use
with an ODI driver in Windows for Workgroups.
1 Install the NetWare client software.
For more information, see “Installing NetWare Client Software” earlier in
this appendix.
2 Install the protocol stack following the instructions that came with it.
3 Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
4 After running SETNET, make sure the NET.CFG and PROTOCOL.INI files contain the
sections shown below.
The following entries assume that IPX/SPX support is loaded.
NET.CFG
LINK DRIVER MACODI
FRAME ETHERNET_802.2
FRAME ETHERNET_802.3
FRAME ETHERNET_II
FRAME ETHERNET_SNAP
PROTOCOL IPX E0 ETHERNET_802.2
PROTOCOL IP 800 ETHERNET_II
PROTOCOL ARP 806 ETHERNET_II
PROTOCOL RARP 8035 ETHERNET_II
LINK SUPPORT
MAX BOARDS 4
BUFFERS 4 1500
MEMPOOL 4095
151 Installing Network Client Software