BMW 01 41 0 155 307 - Manual (Page 43)

43 n
Index
Data
Technology
Repairs
Car care
Controls
Overview
Electric power windows
Open and close the windows
From ignition key position 1:
> Press the switch up to but not past
the resistance point:
The window will continue to open as
long as you hold the switch.
> Press the switch past the resistance
point:
The window will move automatically.
Pressing the switch again stops the
opening cycle.
You can close the windows in the same
manner by pulling the switch.
460de013
In the rear, there are separate switches
under the windows.
After the ignition has been switched off:
You can still operate the power
windows for up to 15 minutes, as long
as neither of the front doors was
opened during that time.
Remove the key from the ignition
and close the doors when you
leave the vehicle, so that children
cannot operate the power windows and
possibly injure themselves.
<
For the convenience opening mode
with the door lock or remote control,
refer to page
34 or 35 .
Safety feature
A contact strip is located on the inside
upper frame of each of the windows. If
pressure is exerted against this contact
strip while a window is being raised, the
system will respond by stopping the
window and then retracting it some-
what.
Despite this safety feature, be
extremely careful that the closing
path of the window is not obstructed
whenever it is being closed. Otherwise,
an object might not touch the contact
strip in some situations (with very thin
objects, for instance).
You can override this safety feature by
pulling the switch beyond the resis-
tance point and holding it.
<
Online Edition for Part No. 01 41 0 155 307 - © 09/00 BMW AG