Apple PC Compatibility Card User Manual
Page 267
11
Refer to “Running the Network Protocol Setup (SETNET) Utility” near the end of this
appendix and follow the instructions there.
12
After running SETNET, make sure your PROTOCOL.INI file contains the following
(assuming TCP/IP is the only loaded protocol):
PROTOCOL.INI
[ndishlp$]
DriverName=ndishlp$
Bindings=MacNDIS$
[protman$]
DriverName=protman$
priority=ndishlp$
[data]
version=v4.00.950
netcards=MacNDIS$,MacNDIS
[MacNDIS$]
DriverName=MacNDIS$
ProtocolDIX=”800,806,8035”
13
Shut down Windows 95.
14
Switch to the Mac OS by typing x-Return.
15
Click Restart PC in the PC Setup control panel.
WARNING
You must run SETNET every time you add or remove a
network protocol, install or upgrade network software, or change
anything in the network control panel. If you do not run SETNET, you
will experience network problems.
267
Installing Network Client Software