Apple Xsan 2 - Manual (Page 69)

Chapter 4 Set up a SAN 69
Rename a SAN
The SAN name appears in the Overview pane of Xsan Admin. The SAN name is initially
set when the SAN is set up. You can change this name using Xsan Admin.
Change the name of a SAN:
1 Open Xsan Admin and click Overview.
2 Choose Edit SAN Properties from the Action pop-up menu (gear).
3 Type a name in the SAN Name field and click OK.
Set up another SAN
You can use Xsan Admin to set up more than one SAN.
Add a new SAN:
1 Install the hardware, connect the Ethernet and Fibre Channel networks, set up the
client computers, set up standby metadata controllers if you have them, set up the
RAID systems, create a metadata array, and set up the primary metadata controller as
instructed earlier in this chapter.
If you’re setting up a SAN for the first time, see the planning guidelines in Chapter 3, “Plan
a SAN,” on page 40 and the instructions at the beginning of this chapter.
2 Open Xsan Admin on the computer that you want to use to set up and manage the
new SAN.
3 Choose File > New and follow the instructions in “Step 8: Configure the SAN” on page 64.
Manage multiple SANs
You can use Xsan Admin to manage more than one Xsan 2 SAN. The computer with
Xsan Admin doesn’t need to be connected to the SAN’s private metadata network or
its Fibre Channel network, but it must be able to connect to the SAN computers via
your public intranet or the Internet.
Manage another SAN:
1 Open Xsan Admin and choose File > New.
2 Click Continue in the Introduction pane.
3 Select “Connect to existing SAN,” click Continue, and follow the onscreen instructions.