Apple WaveBurner 1.5 - Manual (Page 18)

18 Chapter 1 The WaveBurner Interface
Region Info Window
The Region Info window allows you to view and edit information about the currently
selected region and its source audio file.
To show the Region Info window, do one of the following:
 Select a region, then choose Region > Region Info (or press Command-R).
 Double-click on the desired region.
The Previous and Next buttons allow you to step between the preceding and ensuing
regions in the Region list. This can accelerate the editing of a particular parameter in
several regions.
The Cancel and OK buttons cancel or execute any changes made in the Region Info
window.
Note: The Cancel button only works for the currently selected region: If you edited a
Region, then used the Next or Previous button to step to another region, followed by a
click on Cancel, only the changes made to the currently displayed region are canceled.
General Tab
The General tab of the Region Info window displays the following information:
 Region name: Double-click, and type in a new name to edit.
 Length
 Gap To Previous Region: The length of the gap between the start of the selected
region and the end of the previous region. Negative values refer to overlapping
regions—in other words, a given region starts before the previous region has ended.
 Trim Start and Trim End: These two values show the points at which the region
begins (after the start of the audio file) and ends (before the end of the audio file). As
long as the region spans the complete audio file, Trim Start and Trim End will have
values of 0.