Lull 644B Operation Manual - Manual (Page 24)

20
BEFORE OPERATING THE MACHINE
PLAN YOUR WORK
Before you operate, know how and where you will
travel, turn and pickup, lift and place loads.
Choose a smooth level route to prevent possible tipover
or loss of load.
If possible, avoid crossing…
•
Ruts.
•
Ditches.
•
Curbs.
• Exposed railroad tracks.
Note: When these conditions cannot be avoided, keep
the load as low as possible and travel very
slowly and with extreme caution.
Know where there are any blind corner conditions on
the worksite. Before turning a blind corner, stop, sound
your horn, and proceed slowly.
Always maintain safe distances between your forklift
and other equipment that may be on the worksite.
Know the weights of all loads you may be expected to
transport before attempting to lift them. Avoid loads of
loose material if possible. Check that loads are properly
banded or strapped together.
If you will be placing loads at high elevations, remember
your depth perception is decreased because of
distance. Use a signal person near the point where the
load is to be landed.
Insure that adequate clearance is provided between
both rear tail swing and front fork swing of the forklift to
avoid injury to personnel or damage to nearby
equipment.
Know where you will be expected to park your forklift at
the end of the work day, preferably in a level area out of
traffic. If the area is on a slope or incline, position the
forklift at right angles to the slope, set the parking brake,
lower the boom to the ground, and block the wheels.
Remember…
•
Be alert - know that conditions can change.
•
Use common sense - show that you are a
responsible operator.
•
Be a defensive operator - prevent accidents before
they happen.
SAFE MACHINE OPERATION
For safe operation of this rough terrain forklift you must
be a qualified and authorized operator. To be qualified,
you must understand the written instructions supplied
by the manufacturer, have training (including actual
operation of this machine) and know the safety rules
and regulations for the jobsite.
An operator must not use drugs or alcohol which can
affect his alertness and coordination. An operator on
prescription or over-the-counter drugs needs medical
approval to safely operate these machines.
KNOW THE RULES
Most employers have rules governing proper operation
and maintenance of equipment. Before you start work at
a new location, check with your supervisor or the safety
coordinator. Ask about rules you may be expected to
obey.
Make sure you understand the rules covering traffic at
your jobsite. Make sure you recognize and understand
the meaning of all signs, flags, and markings. Make
sure you understand all hand, flag, whistle, siren, or bell
signals. Make sure you know when to use lights, turn
signals, flashers and horn.
PROTECT YOURSELF
Wear all the protective clothing and personal safety
devices issued to you or called for by job conditions.
You may need:
•
A hard hat.
•
Safety shoes.
•
Safety glasses, goggles, or face shield.
• Heavy gloves.
•
Hearing protection.
•
Reflective clothing.
•
Wet weather gear.
•
Respirator or filter mask.
MOUNT AND DISMOUNT
PROPERLY
Always use “Three Point Contact” when mounting or
dismounting the machine. “Three Point Contact” means
that three out of four arms and legs are in contact with
the machine at all times during mount and dismount.
Clean your shoes and wipe your hands before mounting
machine. Always use hand-hold and step when
mounting.
Never use control levers as a hand-hold when mounting
or dismounting the machine. Never step on foot controls
when mounting or dismounting the machine.
Never attempt to mount a moving machine.