CompuSTAR RF-P2W902-SP (Remote 2W902R-SP) - Manual (Page 13)

By Firstech, LLC 24 25 By Firstech, LLC
Advanced System Functions
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the Red Circle twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver s door, hold the button on the back of the RPS Touch until the LEDs go out. Release button and tap again. The number of
solid LEDs represent sensitivity of touch, 1 being the lowest, 5 the highest.
RPS Touch On or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
STEP 1: Enter remote programming mode by holding down the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote
will beep once and the LCD will read “REMOTE MENU” indicating that you have entered programming mode.
STEP 2 : Scroll through the remote options by taping the Function button . Once the LCD reads “RPS-ON” tap the Lock button to turn this
feature on. The LCD will read “RPS-OFF”
STEP 3: Exit remote programming by holding down the Trunk and Key/Start buttons simultaneously for 2.5 seconds. The remote will
beep indicating that you have successfully exited programming. The vibration icon will remain illuminated on the LCD indicating the remote is in
remote mute/vibration mode.
RPS (Remote Paging Sensor) Unlock/Disarm
RPS and car call functions do not require programming, however in order to unlock/disarm your vehicle you must program a 4 digit passcode using the instructions below:
STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4 digit code. You can not have zeros.
Advanced System Functions
STEP 2: Turn ignition key to the on position and leave the driver s door open.
STEP 3:Knock on the windshield in front of the RPS a total of 5 times (each time you knock the LED on the RPS will flash RED). The LED will begin to flash rapidly in
BLUE with successful completion of this step.
STEP 4:Enter the first digit of the desired four digit pass code by knocking on the windshield in front of the RPS the desired number of times. For example, to enter 3,
knock on the sensor 3 times (each time you knock the LED will flash RED) then wait.
STEP 5: The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED begins to flash rapidly in BLUE, enter your second number by
repeating step 4.
STEP 6:Repeat steps 4 & 5 to enter all four numbers.
STEP 7: Turn the ignition OFF - the RPS disarm/unlock passcode is now programmed. Follow steps 3 ? 5 to enter your disarm/unlock code.
Alarm rearm and lock
To rearm, knock on your sensor 5 times.
Alarm disarm and unlock
To disarm, knock on your sensor 5 times. Wait for the Blue LEDs to flash rapidly. Follow STEP 4 and 5 above to enter your 4 digit passcode.
2 Way LCD remote paging
To page a 2 Way LCD remote just knock on the RPS twice.
Knock Panel Sensitivity
To change knock sensitivity, disarm the system and adjust the switch on the rear of the RPS. The larger the circle, the more sensitive the knock sensor is.
>
u
”
r
ll