CompuSTAR RF-P2W902-SP (Remote 2W902R-SP) - Manual (Page 8)

15 By Firstech, LLC By Firstech, LLC 14
General System Functions General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The five button configuration allows for many functions to be
performed through a series of tapping, holding and / or multiple presses of buttons.
Sending Commands
When in range and a command has been sent, the remote will beep and unique LED will flash blue or red. For example, to send a remote start command from
the 2 Way remote, hold down the button for 2.5 seconds. The remote will beep once to confirm the command has been sent and that the remote is in
range. Once the vehicle has successfully remote started, the remote will receive a command indicating the vehicle is running.
Receiving Commands
The remote pager will receive commands indicating the status of the vehicle, confirmation of sending commands and alarm notifications. For example, after
sending the lock command, the pager will receive LED and chirp signals confirming that the vehicle has been successfully locked/armed. To see if your pager is
in range, tap the button for a half second - if the remote receives an audible and LED confirmation then it is in range.
Tap the Lock button for a half second to lock/arm your vehicle. Tap the Unlock button to unlock/disarm your vehicle. If equipped this will also
activate your starter kill and anti grind feature. Also you will not be able to start your vehicle with the key until unlock/disarm.
IMPORTANT: If the alarm has been triggered (Siren is sounding, parking lights flashing, and horn honking), you must wait until the remote pager has
been paged before disarming the alarm -the first button tap will shut off the alarm and the second will unlock/disarm the system.
The system can be configured to passively lock and arm the vehicle. Put the system in passive by tapping the for a half second. The remote will beep
once and the LEDs will illuminate to indicate the system is in passive lock and arming mode.
While in passive mode, the system will lock and arm the alarm 30 seconds after the last door is closed. As an indicator that the vehicle is going to passively lock
and arm, the remote and siren will chirp once and the parking lights will flash once at both 10 and 20 seconds prior to passively locking and arming. If you want
the system to passively arm and not passively lock, ask your local Firstech dealer to turn Option 1-8 to setting II.
Hold the button for 2.5 seconds to remote start an automatic transmission vehicle. If you are in range and the vehicle is ready to remote start, the
remote will beep once and LED flash blue indicating that the remote start command has been successfully transmitted.
If you are in range and the remote beeps three times, there is a remote start error. Refer to the “remote start error diagnostic” on the last page of this
manual for details.
Upon receiving confirmation that your vehicle is running, the remote LED will flash and remote beep to show the run time. The remote start run time can
be programmed for 3, 15, 25, or 45 minutes - ask your local Firstech dealer to adjust Option 2-7 if you would like a run time other than 15 minutes
(default).
IMPORTANT: Your vehicle’s key must be inserted into the ignition and turned to the “on” position prior to driving your vehicle. If the foot brake is
depressed prior to the key being in the “on” position, the vehicle will shut off.