CompuSTAR RF-P2W902-SP (Remote 2W902R-SP) - Manual (Page 4)

7 By Firstech, LLC By Firstech, LLC 6
Quick Reference
2. If you do not have your remote control, you can put the system into valet by turning the ignition key on and then off five times within 7 seconds.
The parking lights will flash once to confirm the system is in valet mode. Shortly after the first flash, the parking lights will flash twice. A remote control is
required to take the system out of valet mode.
3. If your system is set up for a secure valet option (optional), you will not be able to put the system into valet until the proper code has been entered
using the secure valet switch. The secure valet switch is the small button with bright blue LED on the front and if installed is the only way to override the
alarm and/or remote start. Until programmed, the default code is (3, 3).
Removing System Out of Valet:
Tap the for a half second to remove the system out of Valet. On starter and alarm/starter systems, you can turn the key to the Ignition On
position and tap the foot brake 10 times. This will take your system out of Valet Mode. If this does not work you can also repr ogram your remote(s). See
Remote Coding/Programming Routine section for details.
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery.
2W902R-SP:
Turn the remote over and unlock the battery cover by sliding the clear tab up. Slide the battery cover off, revealing the AAA battery. IMPORTANT: Be sure to
observe correct polarity when installing the battery.
1WG7R-SP:
Use a quarter or flat head screwdriver to pry the back cover off of the remote. You can insert the quarter or flat head in the small slot at the bottom of the
remote by the keychain loop. Carefully pry off the back cover using caution that you do not damage the circuit board. Your battery size should be listed on
the battery. Battery size: Two (2) CR2016) Replacements can be purchased from your local Firstech dealer or an electronics store.
Quick Reference
Button(s) Duration Function
Half second Locks doors and if equipped, arms the alarm.
Panic/vehicle locater (flashes vehicle’s parking lights and sounds siren and horn).
Unlocks doors and if equipped, disarms the alarm.
Run time extender. Resets the run time for Turbo Timer or Remote Start.
Trunk release. Triggers the trunk release output and opens the vehicle’s trunk.
Car Check (updates vehicle status on remote) / Secure Auxiliary
Holding this button will start your vehicle. Repeat and this will shut your vehicle down.
This button activates and deactivates multiple features. See the Function Button Menu table below for complete details.
4 seconds
Half second
2.5 seconds
2.5 seconds
Half second
2.5 seconds