Lukas SC 250 M - Manual (Page 16)

16
9.1 General
9. Repairs
Servicing may only be carried out by the manufacturer or personnel trained by the
manufacturer and by authorised LUKAS dealers.
When replacing components, only original LUKAS spare parts must be used (as detailed
in the Spare Parts List) and instructions relating to the use of special tools, assembly
procedures, safety aspects and testing must be complied with (see also the chapter entitled
‘Maintenance and Servicing’).
During assembly, ensure the complete cleanliness of all components, because dirt
can damage the rescue equipment!
WARNING / ATTENTION / CAUTION!
Protective clothes must be worn when repairs are being carried out, because
the equipment can also be pressurised in an idle state.
NOTE:
Register your equipment on the LUKAS Hydraulik GmbH Internet website. The
extended warranty will only be provided for equipment which has already been
registered.
CAUTION!
Because LUKAS rescue equipment is designed for the highest level of
performance, components may only be replaced with those specifi ed in the
spare parts list for the appropriate equipment.
Other components may be replaced only when:
- you have attended the relevant LUKAS training course.
- you have received explicit permission from the LUKAS Customer Service
Department. (After inquiry, examination for the distribution of permission.
Examination in each individual case necessary!)
9.2 Preventative maintenance
9.2.1 Care of the equipment
The equipment casing should be kept clean and oil should be regularly applied to the external
metal services to protect them from corrosion.
9.2.2 Function and load testing
Function and load testing should be carried out in the event of there being any doubt as to
the safety or reliability of the equipment.
LUKAS offers appropriate test equipment to this end.
CAUTION!
When cleaning the equipment, ensure that no cleaning agents are used with pH
values outside the range 5 - 8!