Lukas LKS 31 - Manual (Page 19)

19
Troubleshooting 10.
If it isn’t possible to rectify the malfunctions, inform an authorised LUKAS dealer or the
LUKAS customer service department immediately!
The address for the LUKAS customer service department is:
LUKAS Hydraulik GmbH
Weinstraße 39, D-91058 Erlangen
Postfach 2560, D-91013 Erlangen
Tel.: (+49) 09131 / 698 - 348
Fax.: (+49) 09131 / 698 - 353
Trouble Control Cause Solution
The blade arms
cannot be fully
opened or closed
Insufficient
hydraulic fluid in the
tool
Repair by an
authorised dealer, by
personnel specially
trained by LUKAS, or
by LUKAS itself
Tool does not deliver
the specified power
Tool defective
Hydraulic fluid leaks
on the piston rod
Defective rod seal
Damage to the
piston
Material to be cut
slides between the
blade arms during
cutting
Check pivot bolt Pivot bolt not
tightened with the
prescribed torque
Tighten the pivot bolt.
Tool head cannot be
turned
Tool under pressure Dump the pressure in
the tool