Synergy 5223 - JK 4 Door B-Pillar Cage Kit - Manual (Page 5)

9. Now, test fit the bushing isolated frame tie in by using the ½-13 x 5.0” long bolt
included in the kit.
10. Mock the frame tie in position and take note of where to remove paint on the frame in
preparation for welding. Do not weld at this time.
11. Next, we need to trim some of the factory B-pillar cross bar to fit the new B-pillar tie
in tube.
Mark a line 5/8” in and 4” long as shown in the images below.
**Note** these cuts were a minimum needed to allow us to fit a
tig torch in position for welding. Slightly more material may need
to be removed depending on weld technique used (Tig, Mig, Stick
etc.)