Synergy 5224-A - Jeep JK 4 Door Rear Cage Kit - Manual (Page 4)

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
8. Drill the rear foot plate holes through the floor with a 3/8” drill bit. Use caution when
drilling through on the driver side, the fuel filler hoses are underneath these bolt
holes. Insert 3/8 x 1” bolts and flange nuts with a washer under the bolt head.
Tighten the 3/8” bolts and the seat and seat belt nuts evenly.
9. Position the C-pillar upright tubes between the foot plate and the bend in the C-pillar
beneath the C-pillar cross bar. The top of the tube is about 4” in front of the seat belt
mounting bung. Clean off the paint on the factory roll bar where you will weld the
tube. The bottom of the tube should be centered on the foot plate. Make sure the rear
seats will fold back all the way and lock without hitting these tubes.